Brushed Steel Plate

I’ve cut myself a piece of steel for the sign and managed to get it completed to the point where I can attach the EL wire.

I first grabbed two washers, bent them slightly and welded them to the steel. Once complete these can be used to tie of the hanging wire on the back.

I then used a grinder to remove light surface rust and to give the steel an industrial “brushed” look.

I sprayed the steel with 4 coats of clear coat. It’s a top coat suitable for car body work and seems to stick to the steel well.

In what I personally believe was a stroke of genius, I found that if I pressed hard and drew over my design on paper with a ball point pen, the design would slightly scratch the varnish, effectively transferring the design onto the steel.

I then drilled a couple of dozen 3mm holes with a drill press, sprayed another clear coat onto the steel and it was ready for the EL wire to be attached.

Unfortunately I didn’t take any photos in between, but here’s a picture of the steel, ready for the EL wire to be attached.

If you look closely, you can see the design “scratched” into the clear coat.

You May Also Like

About the Author: John

Leave a Reply

Your email address will not be published. Required fields are marked *